Installing MPSS

All,

I Recently obtained a xeon-phi and I have been trying to install it. I have centos 6.5. I followed the instruction and installed the mpss service using yum install MPSS. After installing, i do lsmod | grep mic and I can see the mic. Furthermore, I can see xeon phi in lspci -vv

Co-processor: Intel Corporation Xeon Phi coprocessor SE10/7120 series (rev 20)

        Subsystem: Intel Corporation Device 7d99

        Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-

        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-

        Interrupt: pin A routed to IRQ 255

        Region 0: Memory at <unassigned> (64-bit, prefetchable) [disabled] [size=16G]

        Region 4: Memory at f2000000 (64-bit, non-prefetchable) [disabled] [size=128K]

        Capabilities: [44] Power Management version 3

                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot-,D3cold-)

                Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-

        Capabilities: [4c] Express (v2) Endpoint, MSI 00

                DevCap: MaxPayload 256 bytes, PhantFunc 0, Latency L0s <4us, L1 <64us

                        ExtTag+ AttnBtn- AttnInd- PwrInd- RBE+ FLReset-

                DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported-

                        RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop+

                        MaxPayload 256 bytes, MaxReadReq 512 bytes

                DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq+ AuxPwr- TransPend-

                LnkCap: Port #0, Speed 5GT/s, Width x16, ASPM L0s L1, Latency L0 <4us, L1 unlimited

                        ClockPM- Surprise- LLActRep- BwNot-

                LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- CommClk+

                        ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-

                LnkSta: Speed 5GT/s, Width x8, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-

                DevCap2: Completion Timeout: Range AB, TimeoutDis+, LTR-, OBFF Not Supported

                DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, OBFF Disabled

                LnkCtl2: Target Link Speed: 5GT/s, EnterCompliance- SpeedDis-

                         Transmit Margin: Normal Operating Range, EnterModifiedCompliance- ComplianceSOS-

                         Compliance De-emphasis: -6dB

                LnkSta2: Current De-emphasis Level: -3.5dB, EqualizationComplete-, EqualizationPhase1-

                         EqualizationPhase2-, EqualizationPhase3-, LinkEqualizationRequest-

        Capabilities: [88] MSI: Enable- Count=1/16 Maskable- 64bit+

                Address: 0000000000000000  Data: 0000

        Capabilities: [98] MSI-X: Enable- Count=16 Masked-

                Vector table: BAR=4 offset=00017000

                PBA: BAR=4 offset=00018000

        Capabilities: [100 v1] Advanced Error Reporting

                UESta:  DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-

                UEMsk:  DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-

                UESvrt: DLP+ SDES- TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-

                CESta:  RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+

                CEMsk:  RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+

                AERCap: First Error Pointer: 00, GenCap- CGenEn- ChkCap- ChkEn-

However I get the following

[root@apollo1 mpss-3.2.1]# lsmod | grep mic

mic                   591295  0

microcode             112685  0

[root@apollo1 mpss-3.2.1]# sudo modprobe mic

[root@apollo1 mpss-3.2.1]# sudo micctrl --initdefaults

[Warning] No Mic cards found or specified on command line

Can someone help me out. Am i doing something wrong ?